Wrangler L4-2.4L VIN 1 (2006)
Fig. 35 YOKE BEARING CAP REMOVAL
5. Position yoke with the sockets in a vise (Fig. 35).
6. Tighten vise jaws, to force bearing cap into the socket (receiver).
7. Release vise jaws. Remove sockets and bearing cap forced out of the yoke.
8. Repeat above procedure for the remaining bearing cap and remove cross from propeller shaft yoke.
INSTALLATION
CAUTION: Keep cross and bearing cap straight during installation. Failure to heed caution may result in damage.
Fig. 36 AXLE SHAFT OUTER U-JOINT
1. Pack bearing caps 1/3 full of wheel bearing lubricant (Fig. 36). Apply extreme pressure (EP), lithium-base lubricant to aid in installation.