Wrangler L4-2.4L VIN 1 (2006)
control stalk. The intermittent wipe logic circuit within the right multi-function switch monitors inputs from the front wiper switch, the front washer
switch, the front wiper delay variable resistor, and the front wiper motor park switch. The programming of the logic circuit then determines the proper
outputs to the front wiper motor. The low current logic circuit controls the high current front wiper motor by pulling the control coil of the integral wiper
motor relay to ground. The wiper motor relay switches a circuit that feeds battery current to the low speed brush of the front wiper motor.
When the ignition switch is in the Accessory or ON positions, battery current from a fuse in the Power Distribution Center (PDC) is provided to the
wiper and washer system fuse in the fuse block. This fuse provides battery current through a fused ignition switch output (run-acc) circuit to the right
multi-function switch. The electronic intermittent wipe logic circuit receives a logic ground through the cross body harness from a take out with an eyelet
terminal connector located under a ground screw on the left inner cowl side panel, below the left end of the instrument panel. Refer to the owner's
manual in the vehicle glove box for more information on the features, use and operation of the right multi-function switch.
Fig.16 Rear Wiper And Washer Switch
REAR WIPER/WASHER SWITCH
The rear wiper and washer switch is located in the accessory switch bezel near the bottom of the instrument panel center stack area on the instrument
panel. The single two-function switch is molded from black plastic and is secured by a snap fit in a dedicated receptacle molded into the back of the
accessory switch bezel. A single six pin connector receptacle is molded into the back of the switch housing. Only the switch toggle button is visible
through the lower opening of the instrument panel center bezel. The remainder of the switch is concealed behind the accessory switch bezel within the
instrument panel. The rear wiper and washer switch contains switches to control both the rear wiper and the rear washer, and also has an integral
incandescent illumination lamp with a serviceable bulb. The switch rocker is identified with an International Control and Display Symbol icon for
windshield wiper and washer, and the icon is illuminated from behind when the exterior lamps are turned ON. The rear wiper and washer switch cannot
be repaired and, if faulty or damaged, the entire switch unit must be replaced. The switch illumination lamp bulb is available for service replacement.
The rear wiper and washer switch features a detent in the Wipe position, and a momentary Wash position. The switch toggle button is pushed downward
to its detent to activate the rear wiper system, and down again to a momentary position to activate the rear washer system. Pushing the switch toggle
button upwards moves the switch to the OFF position, which also has a detent. When the ignition switch is in the ON position, battery current from a fuse
in the Power Distribution Center (PDC) is provided to the rear wiper and washer system fuse in the fuse block, which provides battery current to the
switch through a fused ignition switch output (run) circuit. The switch is connected to the vehicle electrical system through a single dedicated take out
and connector in the instrument panel wire harness. The intensity of the switch illumination lamp is controlled by a lamp driver output from the
instrument cluster based upon the panel lamps dimmer input to the cluster from the left multi-function switch. Refer to the owner's manual in the vehicle
glove box for more information on the features, use and operation of the rear wiper and washer switch.