Wrangler L4-2.5L VIN P (1999)
Electronic Noise Suppressor: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
Engine-to-body Ground Strap
Engine-To-Body Ground Strap Remove/Install
1. Remove the screw that secures the engine-to-body ground strap eyelet to the hood panel center reinforcement.
2. Remove the screw that secures the engine-to-body ground strap eyelet to the dash panel.
3. Remove the nut that secures the engine-to-body ground strap eyelet to the stud on the left upper rear corner of the engine cylinder head.
4. Remove the engine-to-body ground strap eyelet from the stud on the left upper rear corner of the engine cylinder head.
5. Remove the engine-to-body ground strap from the engine compartment.
Engine-to-frame Ground Strap
Engine-To-Frame Ground Strap Remove/Install
1. Remove the nut that secures the engine-to-frame ground strap eyelet to the forward ignition coil mounting stud on the right side of the engine.
2. Remove the engine-to-frame ground strap eyelet from the forward ignition coil mounting stud on the right side of the engine.
3. Remove the screw that secures the engine-to-frame ground strap eyelet to the top of the right frame rail.
4. Remove the engine-to-frame ground strap from the engine compartment.
INSTALLATION
Engine-to-body Ground Strap