Borrego 2WD V6-3.8L (2009)
Door Module: Description and Operation
Driver Door Module (DDM)
System Block Diagram
Description
The driver door module(DDM) is a part of a Controller Area Network (CAN), and performs CAN communication with the FAM, IPM, RAM, ADM,
IMS and SCM. Driver controls driver side power window switch button located inside of the driver side door to operate power window, mirror, door
lock and unlock.
1. Two manual operations (up and down) for four p/windows. However, on the driver's seat the auto up/down operation must be possible.
2. Manually operating the mirror position by the manual switch (Up, Down, Right, and Left)
3. Saving and replacing the mirror position by RKE -> For 2 persons
4. Out side mirror auto reverse operation
5. Out side mirror fold/unfold power control
6. Central door lock/unlock function
7. Door courtesy lamp control
8. Out side mirror defog control
9. Illumination control
10. Outside mirror turn signal lamp control.
Control Function
Power Window
Power Window Control
1. According to the input at DR as window manual up/down, RL window manual up/down, RR window manual up/down Switch of the SW ASSY
P/WDW main, the inputted signal will be sent out (ADM, RAM) through CAN Communication. Simultaneously, DDM will send out manual
up/down, auto up/down signal.
(message : AD Window Motor Ctrl, RLD Window Sw Sts, RRD Window Sw Sts)
2. Driver Door Window control :
A. Safety spec. : According to the input of Driver Door Window Auto, up/down SW, output Manual up/down, AUTO UP/DOWN signal to Safety
window module.
B. Down Only spec. : According to the input of Driver Door Window Auto, up/down SW, Operate by the input of Driver Door Window auto,
up/down SW.
-
If the motor operation lasts over 10sec ±1sec from Manual up/down SW input, output of the motor will be OFF.
-
Current sensing method adopted Stop current : 13 ± 1A, delay time : 0.5sec ± 0.2sec
Power Window Lock
Under the condition, power window lock SW of SW ASSY P/WDW main(DDM) is "ON", Instruction from power window lock is sent out through can
message, there by power window operation is controlled only from the driver's door and prohibited from any other doors.
(Message: Power Window Lock Sw Sts = LOCK)
