Borrego 2WD V6-3.8L (2009)
Vacuum Brake Booster: Service and Repair
Repair Procedures
Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable
2. Remove the air cleaner assembly (A).
3. Disconnect the vacuum hose (A) from the brake booster.
4. Remove the master cylinder.
5. Remove the ECM.
6. Remove the ABS control module.
7. Remove the snap pin (A) and clevis pin (B).
8. Remove the mounting nuts.
Tightening torque:
12.7 - 15.7 N.m (1.3 - 1.6 kgf.m, 9.4 - 11.6 lb-ft)
9. Remove the brake booster.