Borrego 2WD V6-3.8L (2009)
36. Install the engine cover (A).
37. Connect the battery negative cable(A).
NOTE:
-
Refill engine oil.
-
Clean the battery posts and cable terminals with sandpaper. Assemble and then apply grease to prevent corrosion.
-
Inspect for fuel leakage.
-
After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds
and fuel line pressurizes.
-
Repeat this operation two or three times, and then check for fuel leakage at any point in the fuel lines.
-
Refill radiator and reservoir tank with engine coolant.
-
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
-
Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
-
Put radiator cap on tightly, then run the engine again and check for leaks.
