Borrego 2WD V6-3.8L (2009)
CAUTION:
Engine coolant will run out when the hoses are disconnected; drain it into a clean drip pan. Be sure not to let coolant spill on electrical parts or
painted surfaces. If any coolant spills, rinse it off immediately.
6. Remove the crash pad .
7. Remove the cowl cross bar assembly.
8. Disconnect the connectors from the temperature control actuator, the mode control actuator and the evaporator temperature sensor.
9. Remove the heater & blower unit after loosening 3 mounting nuts.
10. Remove the heater core cover( A).
11. Remove the heater core(A) from heater unit.
12. Loosen the heater unit lower case mount screw and then remove the heater unit lower case(A).
13. Remove the evaporator core(A).
