Borrego 2WD V6-3.8L (2009)
-
Ensure that the valve hole and mating face of the wheel are clean.
1. Slide the sensor-valve unit through the valve hole of the rim. Hold the sensor against the rim and the rubber grommet against the sealing surface.
2. Insert the nut over the valve stem and then tighten the nut.
3. Continue to tightening the nut until contact with the rim and then tighten to 3.5 - 4.5Nm.
CAUTION:
-
Tighten slowly with quarter turn steps until the final torque is reached.
-
Do not exceed allowed torque.
-
Do not use electric or pneumatic tools.
4. Check that the sensor is firmly attached to the rim.
CAUTION:
Risk of damage during the tire installation/ removal if the sensor is not firmly attached to the rim.
