Borrego 2WD V6-3.8L (2009)
Engine Control Module: All Technical Service Bulletins
Campaign SA046 - ECM Update For MIL/Various DTC's Set
GROUP: ENGINE
NUMBER: 074
MODEL: 2009 BORREGO (HM) w/3.8L ENGINE
SUBJECT:
COMBINED TSB / SERVICE ACTION: PCM UPGRADE P0110, P0111, P0116 AND P161B (SA046)
This bulletin provides information related to the ECM software upgrade of some 2009MY Borrego (HM) vehicles with 3.8L engines which may
experience a malfunction indicator lamp illuminated with the PCM (Powertrain Control Module) system-related DTC(s), P0110, P0111, P0116 and
P161B.
^ P0110: Intake Air Temperature sensor 1 Circuit
^ P0111: Intake Air Temperature sensor 1 Circuit Range / Performance
^ P0116: Engine Coolant Temperature Circuit Range / Performance
^ P161B: ECM Torque Calculation Performance
To improve customer satisfaction, Kia is requesting the completion of this Service Action on all affected 2009 Borrego (HM) vehicles w/3.8L engine.
For vehicles not on the Affected Vehicles List, but with a customer concern, perform the following procedure outlined in this bulletin and submit a
warranty claim per "customer concern" (Standard TSB) claim information.
To correct this condition, the PCM should be reprogrammed using the GDS download as described in this bulletin.
NOTICE
A Service Action is a repair program without customer notification that is performed during the warranty period. Any dealer request to perform this
repair outside the warranty period will require DPSM approval.
Repair status for a VIN is provided on WebDCS (Service>Warranty Coverage> Warranty Coverage Inquiry>Campaign Information). Not Completed
Recall/Service Action reports are available on WebDCS (Consumer Affairs>Not Completed Recall Recall VIN>Select Report).
The issue number is SA046.
UPGRADE EVENT NAME
NOTICE
^ A fully charged battery is necessary before ECU upgrade can take place. DO NOT connect a battery charger to the vehicle during ECU upgrade. Make
sure the blower motor is "OFF" during ECU upgrade.
^ All ECU upgrades must be done with the ignition key in the "ON" position.
^ Be careful not to disconnect any cables connected to the vehicle or GDS during the ECU upgrade procedure.