Borrego 2WD V6-3.8L (2009)
4. Connect the Main 16-pin DLC cable (GHDM 241000) to the OBD-II connector, located under the driver's side of the instrument panel.
5. With the ignition key ON, turn ON the VCI and GDS tool. Access the GDS vehicle identification number (VIN) screen and configure the vehicle
using the VIN AUTO DETECT Function.
*NOTICE
Global Diagnostic System (GDS) users should access the "Notice" function from the GDS Main Screen for instructions regarding ECU upgrade
events.
6. Once back at the GDS Main Screen, select ECU upgrade from the bottom right-hand corner. Next select Auto Mode, Engine. Perform the ECU
upgrade in accordance with normal GDS tool ECU upgrade procedures.
*NOTICE
DO NOT attempt to perform a Manual Mode PCM upgrade unless Auto Mode fails. Always follow the instructions given on the GDS tool in either
Auto or Manual mode. See table for Manual Mode passwords. In addition, a PCM reset is required if Auto Mode fails; refer to the table below for
procedure.
*NOTICE
DO NOT attempt to perform a Manual Mode PCM upgrade unless Auto Mode fails. Always follow the instructions given on GDS tool in either
Auto or Manual mode. See table for Manual Mode passwords. In addition, a PCM reset is required if Auto Mode fails; refer to the table for
procedure.
7. When the GDS tool reports that the ECU upgrade has been successfully completed, click OK, turn OFF the ignition key, and wait at least 10 seconds
before attempting to start the engine.
8. Check for Diagnostic Trouble Codes using the GDS and erase any DTCs stored in the Engine and Transaxle control modules.
WARRANTY CLAIM INFORMATION:
