Borrego 4WD V6-3.8L (2009)
Alarm Module: Service and Repair
Replacement
[USA]
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel.
3. Disconnect the 5P connector of the Immobilizer unit and then remove the Immobilizer unit (A) after loosening a bolt.
4. Installation is the reverse of removal procedure.
[CANADA]
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel.
3. Disconnect the immobilizer unit connector and then remove the immobilizer unit(A) and bracket after loosening a shear bolt or removing the unit
from the mounting bracket (B) using a flat-up screwdriver.
NOTE:
-
When removing the shear bolt, punch the shear bolt using a centering punch.
-
And drill its head off with a drill bit.
-
Be careful not to damage the SMARTRA unit.
4. Installation is the reverse of removal procedure.