Borrego 4WD V6-3.8L (2009)
Rear Bumper: Service and Repair
Repair Procedures
Replacement
NOTE:
-
After remove the rear combination lamp.
-
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
-
Put on gloves to protect your hands.
-
Be careful not bend or scratch the cover and other parts.
1. Remove the side bumper mounting screws.
2. Disconnect the connector (A).
3. Remove the mounting nuts.
4. Loosen the rear bumper cover screws and clips.
5. Remove the rear bumper cover (A).
6. Installation is the reverse of removal.
NOTE:
-
Replace any damaged clips.
