Borrego 4WD V6-3.8L (2009)
Rear Door Window Motor: Service and Repair
Module Assembly Replacement
1. Remove the following parts :
A. Door trim
B. Window glass
C. Outside handle
2. Loosen the mounting screw (A).
3. After loosening the door module mounting bolts, remove the door module (A).
4. Disconnect the connector (A).
5. Detach the clips, remove the wiring harness (B).
6. Installation is the reverse of removal.
NOTE:
-
Grease should be applied to areas where there is whole parts.
-
Make sure connectors are connected properly and each rod is connected securely.
-
Make sure the door lock and open properly.
