Borrego 4WD V6-3.8L (2009)
Seat Heater: Testing and Inspection
Inspection
First Seat Heater
1. Check for continuity and measure the resistance between No.1 and NO.3 terminals.
Standard value
Cushion :4.5Ohms ± 10%, Back : 3.96Ohms ± 10%
2. Operate the seat warmer after connecting the 3P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
HI :107.6 ± 35.6°F (42 ± 2°C) (Cushion),
125.6 ± 35.6°F (52 ± 2°C) (Back)
3. Check for continuity between the terminals after disconnecting the connector.
2nd Seat Heater
1. Check for continuity and measure the resistance between No.1 and NO.3 terminals.
Standard value
Cushion :4.36Ohms ± 10%
2. Operate the seat warmer after connecting the 3P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion :104 ± 35.6°F (40 ± 2°C)