Borrego 4WD V6-3.8L (2009)
Thermostat: Service and Repair
Removal
NOTE:
Do not operate the engine without the correct thermostat installed ; this may cause reduced cooling efficiency.
1. Drain engine coolant so its level is below thermostat.
2. Remove the water inlet fitting (A) and the thermostat (B).
Installation
1. Place the thermostat in thermostat housing.
(1) Install the thermostat with the jiggle valve upward.
(2) Install a new thermostat (B).
2. Install the water inlet fitting (A).
Tightening torque :
16.7 - 19.6N.m (1.7 - 2.0kgf.m, 12.3 - 14.5lb-ft)
3. Fill with engine coolant.
4. Start engine and check for leaks.