Borrego 4WD V6-3.8L (2009)
ADM
LOCK/UNLOCK is performed when ADM receives Door Lock Ctrl CAN signal from IPM
Main Functional Diagram
Lock/Unlock With Door Lock Switch
Description
Lock/unlock with Door Lock Switch does not depend on Ignition Key position.
IPM
Description
Working conditions
For vehicle not equipped with burglar alarm :
All following requirements are applicable.
For vehicle equipped with burglar alarm :
In ARM alarm state, there is no action on door lock switch. So, all following requirements are applicable in alarm state DISARM, PREARM, 30SEC
DELAY, ARM_WAIT, ALARM, AFTER_ALARM and REARM.
Lock
Description
Locking process
Upon a transition of Assist door lock switch status or Driver door lock switch status CAN signal from any value to LOCK value, IPM issues Door Lock
Ctrl CAN signal with value LOCK_ALL for 500 ms.
Unlock
Description
Unlocking process
Upon a transition of Assist door lock switch status or Driver door lock switch status CAN signal from any value to UNLOCK value, IPM issues Door
Lock Ctrl CAN signal with value UNLOCK_ALL for 500 ms.
Unlocking process
When Assist door lock switch status and Driver door lock switch status CAN signal state change at the same moment, IPM uses Driver door lock switch
status state for lock/unlock operation
This locking/unlocking process doesn't depend on the Driver Door Open Switch status, Assist Door Open Switch status, Rear Doors Open Switch status
Tailgate Open Switch Status.
This locking/unlocking process doesn't activate or deactivate hazard lamps, horn or interior lamps.