Borrego 4WD V6-3.8L (2009)
Clockspring Assembly / Spiral Cable: Service and Repair
Repair Procedures
Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the airbag module mounting bolts (2EA).
3. Disconnect the horn connector (A).
4. Release the connector locking pin, then disconnect the driver airbag module connector(B).
CAUTION:
The removed airbag module should be stored in a clean, dry place with the pad cover face up.
5. Remove the steering wheel and steering wheel column cover.
6. Disconnect the clock spring and horn connector, then remove the clock spring.
Installation
1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3. Connect the clock spring harness connector and horn harness connector to the clock spring.
4. Set the center position by getting marks between the clock spring and the cover into line. Make an array the mark (><) by turning the clock spring
clockwise to the stop and then 2.4 revolutions counterclockwise.