Borrego 4WD V6-3.8L (2009)
Impact Sensor: Service and Repair
Side Impact Sensor (SIS)
Components and Components Location
Components
Repair procedures
Removal
Front Side Impact Sensor
CAUTION:
-
Removal of the airbag must be performed according to the precautions/procedures described previously.
-
Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front door trim.
3. Disconnect the front side impact sensor connector and remove the front side impact sensor mounting screws.
Rear Side Impact Sensor
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the rear seat.
3. Disconnect the rear side impact sensor connector.
4. Loosen the rear side impact sensor mounting bolt and remove the rear side impact sensor.