Borrego 4WD V6-3.8L (2009)
Seat Belt Tensioner: Service and Repair
Repair Procedures
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the lower anchor bolt.
3. Remove the following parts.
A. Door scuff trim
B. Center pillar trim
4. Remove the upper anchor bolt.
5. Loosen the Seat Belt Pretensioner mounting bolt and remove the Seat Belt Pretensioner.
6. Disconnect the Seat Belt Pretensioner connector.
Installation
1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable and wait for at least three minutes.
3. Connect the Seat Belt Pretensioner (BPT) connector.
4. Install the Seat Belt Pretensioner (BPT) with a bolt.
Tightening torque
Bolt B: 39.2 - 53.9 Nm (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb.ft)
5. Install the upper anchor bolts.
Tightening torque
: 39.2 - 53.9 Nm (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb.ft)
6. Install the following parts.
A. Center pillar trim
B. Door scuff trim
7. Install the lower anchor bolts.
Tightening torque
: 39.2 - 53.9 Nm (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb.ft)
8. Reconnect the battery negative cable.
9. After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.