Borrego 4WD V6-3.8L (2009)
8. Check with an ohmmeter that no continuity exists between the commutator (A) and armature coil core (B), and between the commutator and
armature shaft (C). If continuity exists, replace the armature.
Inspect Starter Brush
Brushes that are worm out, or oil-soaked, should be replaced.
Starter Brush Holder Test
1. Check that there is no continuity between the (+) brush holder (A) and (-) brush holder (B). If there is no continuity, replace the brush holder
assembly.
Overrunning Clutch
1. Slide the overrunning clutch along the shaft.
Replace it if does not slide smoothly.
2. Rotate the overrunning clutch both ways.
Does it lock in one direction and rotate smoothly in reverse? If it does not lock in either direction or it locks in both directions, replace it.
3. If the starter drive gear is worn or damaged, replace the overrunning clutch assembly. (the gear is not available separately).
Check the condition of the flywheel or torque converter ring gear if the starter drive gear teeth are damaged.
