Borrego 4WD V6-3.8L (2009)
(2) If "SET SWITCH" push over 10 sec , it will enable Get-on/off gearing operation to set or cancel.
(3) Get-off gearing operation is set in case that CAN DATA (IMS_SCM Cfg) transmitted from IPM is "1"or"2"
( 0: Not Equipped, 1: Equipped_ALL ON, 2: Equipped_SCM ON, 3: Equipped_ALL OFF)
(4) Get-off operation conditions
When IGN changes from any positions excepting "IGN = OFF "to "IGN = OFF", get-off operations is operated.TELE motor of steering
column moves max forward and TILT motor of steering column moves max upward.
(If limit SW is off, motor operation stops)
(5) get-on operation conditions
When IGN changes from "IGN = OFF" to any positions excepting "IGN = OFF", get-on operations is operated.
(6) Renewal condition of get- on gearing operation
When key state changes from "KEY IN" to "KEY OUT "
(7) Conditions to ban or halt Get-on/off gearing operation.
If any one of the following conditions is met, Get-on/off gearing operation will be prevented or halted.
A. When "P_Position Sw Sts""in CAN BUS data transmitted from IMS is not ON.
B. When "Vehicle Speed" in CAN BUS data transmitted from CLU is "3km/h" or faster.
C. When TILT & TELE is under manual SW operation.
D. When the limit of operating direction is off.
E. When CAN data ( IMS_AutoSw) transmitted from DDM is off.
(Operation is completed in case that CAN data ( IMS_AutoSw) changes form "ON" to "OFF" during operation)