Borrego 4WD V6-3.8L (2009)
8. Remove the wheel speed sensor(A) and the parking brake cable(B) from the rear axle carrier.
9. Disconnect the rear shaft end(A) from knuckle.
10. Insert a pry bar (A) between the differential case and joint case , and separate the driveshaft (B) from the differential case.
CAUTION:
-
Use a pry bar being careful not to damage the differential and joint.
-
Do not insert the pry bar too deep, as this may cause damage to the oil seal.
-
Do not pull the driveshaft by excessive force it may cause components inside the joint kit to dislodge resulting in a torn boot or a damaged
bearing.
-
Plug the hole of the differential case with the oil seal cap to prevent contamination.
-
Support the driveshaft properly.
-
Replace the retainer ring whenever the driveshaft is removed from the differential case.
