Forte L4-2.0L (2010)
5. With the ignition key ON, turn ON the VCI and GDS tool. Access the GDS vehicle identification number (VIN) screen and configure the vehicle
using the Auto VIN Detect function.
6. Once back at the GDS Main Screen select ECU Upgrade tram the bottom right-hand corner. Next select Auto Mode and then Engine Perform the
ECM upgrade in accordance with normal GDS too ECM upgrade procedures.
MANUAL MODE ECM UPGRADE PASSWORDS:
* Do NOT perform Manual Mode ECM upgrade unless Auto Mode fails
7. When the GDS too reports that the ECM upgrade has been successfully completed click OK turn OFF the ignition key and wait at east 10 seconds
before attempting to start the engine.
8. Check for Diagnostic Trouble Codes using the GDS and erase any DTCs stored such as EPS ESC and TPMS Due to CAN BUS multiple DTCs
maybe set during reprogramming.