Forte L4-2.0L (2010)
Installation
Sensor Reinstallation
1. Hold the sensor and the seal washer, then extract it, this also extracts the seal. Take care to not damage the valve thread.
2. Clean the sensor and the valve stem holding the valve using a dry cloth as shown on the picture. Take care to support the rear of the valve with a
thumb so that there is no movement of the stem.
3. When removing the sensor, a new washer and seal must be used. Insert these up to the base of the sensor, making sure to secure the valve base
with a thumb, as shown. Wipe the seal and threading.
4. Insert the valve, in the valve hole, without modifying the angle of the stem (retain position of delivery). The laser marking should be visible to the
operator.
5. When the valve is completely inserted, maintain the sensor in contact with the rim (as shown on the picture), then screw manually the nut until it is
in contact with the wheel (without force).