Optima V6-2.7L (2003)
2.
Check the bulkhead at the location indicated for a green campaign completion label.
3.
If a campaign completion label exists on the bulkhead, NO FURTHER ACTION IS REQUIRED.
4.
If a green campaign completion label DOES NOT EXIST on the bulkhead, continue on to Repair Procedure.
REPAIR PROCEDURE:
1.
Open hood, remove CKP sensor connector from retainer and disconnect from harness connector.
2.
Raise and support vehicle on hoist. Remove retaining bolt from CKP sensor and remove sensor.
3.
Apply a small amount of clean engine oil to "0" ring on new sensor and install into engine block.
4.
Reinstall retaining bolt and torque to 5-6 Nm (42-52 lb-in).
