Optima V6-2.7L (2003)
4.
Remove the two (2) bolts at the rear of the seat track. Remove the seat assembly from the front two (2) seat frame studs and tilt the seat rearward
to gain access to the front of the seat bottom.
5.
Disconnect the negative battery cable on power seat equipped models after removing the seat bolts on both the drivers and passenger front seats.
6.
If S-04/S-05 has come free of the black connector holder re-install it. Unplug Connector S-08/S-09.
7.
Using a body trim tool remove the harness retaining tie wrap from it's factory inserted position to the seat bottom (A). In some instances the
harness connector may have come loose from it's factory mounting position in the seat bottom (A) shown here at position (B).
8.
Cut the tie wrap from position (B).
9.
Mark a new hole relocation point that is 4" (102 mm) horizontally from bottom edge of S-04/S-05 mounting clip and 1" (25 mm) vertically from
the edge of the seat flange. Using a 17/64" (7 mm) drill bit and a drill stop drill a hole into the seat bottom.
CAUTION:
caution: Use extreme care to avoid drilling through the seat cushion material and underlying fabric.
