Optima V6-2.7L (2003)
7a. In preparation for drilling the 40 mm hole-saw site three (3) in the right front, the following method must be used to insure proper drilling location.
Locate the center point of the right side subframe bushing bolt, use a straight edge to draw a horizontal line for 19 mm inboard. From the end of the 19
mm horizontal line, use a straight edge to draw a vertical line for 294 mm. From the end of the 294 mm vertical line, mark this location as the center
point for drilling. Drill this location using the 40 mm hole-saw. (Drill Speed Recommendation: 380 ~ 470 rpm).
CAUTION
NOTICE
7b. In preparation for drilling the 40 mm hole-saw site four (4) in the left front, the following method must be used to insure proper drilling location.
Locate the center point of the left side subframe bushing bolt, use a straight edge to draw a horizontal line for 21 mm inboard. From the end of the 21
mm horizontal line, use a straight edge to draw a vertical line for 266 mm. From the end of the 266 mm vertical line, mark this location as the center
point for drilling. Drill this location using the 40 mm hole-saw. (Drill Speed Recommendation: 380 ~ 470 rpm).
