Optima V6-2.7L (2003)
11. Remove the shift lever assembly.
12. Remove the clip, flange nut from the transaxle sides.
13. Remove the transaxle control cable assembly.
14. Remove the shift lock cable and the key lock cable.
INSTALLATION
1. Apply a coating of the specified grease to the interior of the adjust bushing.
Specified grease........Chassis grease SAE J310, NLGI No.O
2. Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.
3. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in the position shown in the
picture.
4. Install the shift lever assembly and connector.
5. When connecting the control cable to the shift lever mounting bracket, install the clip until it contacts the control cable.
6. Install the control cable, the key lock cable and the shift cable mounting bolt.
7. Position the console and tighten eight screws.
8. Install the center panel after connecting 12V power outlet pin, then tighten two screws.
