Optima V6-2.7L (2003)
5. Prime the contact area on the body.
6. Reprime the same area on the inside surface of the glass.
Do not permit any primed surface to become contaminated with dirt, water, oil, etc. Do not touch primed surfaces with your hands. Contamination
will affect adhesion.
7. Install the self-adhesive foam dam to the body where the original dam had been.
NOTE: The following cure times may be critical. Attempting to replace a windshield in ambient temperature over 95 °F (35 °C) should be
avoided because the surface of the sealant may harden before completing the application.
8. Apply the urethane bead to the body just outside the dam. The bead should be slightly higher than the dam.
