Rio L4-1.6L (2004)
d. Measure the clearance between the end of the gauge and the push rod of the power brake unit. If it is not 0 inch (0 mm), loosen the push rod
locknut and turn the push rod to make the adjustment.
NOTE: By making the above adjustment, the clearance between the push rod and piston (after installation of the brake master cylinder to the
power brake unit) will be as shown in the displayed table.
2. Install the master cylinder attaching washers and nuts. Tighten the master cylinder attaching nuts.
Tightening torque: 9.81 - 15.7 Nm (1.0 - 1.6 kg-m, 7 - 12 ft. lbs.)
3. Tighten the brake pipe flare nut with the SST.
Tightening torque: 13 - 22 Nm (1.3 - 2.2 kg-m, 10 - 16 ft. lbs.)
4. Connect the low fluid level sensor wiring.
5. Bleed the brakes.
