Rio L4-1.6L (2004)
6. If the preload is not within the specification, select the proper spacer from the table to adjust it.
Notice: Increase the spacer thickness to reduce the preload and decrease it to increase the preload when a spacer is changed by 1 rank, the preload
changes 0.2 to 0.4 Nm (2.0 - 4.0 kg-cm, 1.7 - 3.5 inch lbs.) The rank marking is stamped on the outer periphery of the spacer.
7. Remove the SST.
Wheel bearing (outer & inner), oil seal (outer), and spacer
Notice: Completely fill the shaded area shown in the figure with a lithium grease.