Rio L4-1.6L (2004)
3. To inspect for a worn clutch disc, measure the depth to the rivet heads with a slide caliper.
Depth: 0.012 inch (0.3 mm) min.
4. Inspect the run-out of the clutch disc.
Lateral run-out: 0.027 inch (0.7 mm) max.
Vertical run-out: 0.039 inch (1.0 mm) max.
5. Inspect for wear or rust on the splines. Remove any minor rust.
Installation
1. Position the clutch disc on the flywheel and hold it in position with SST.
Notice: Use the marks which were made during removal for the alignment reference.
2. Position the pressure plate on the flywheel and install the pressure plate bolts.
Notice: Tighten the bolts evenly and alternately to prevent distortion of the pressure plate.
