Rio5 L4-1.6L (2006)
3. CENTRAL DOOR LOCK/UNLOCK (Included 2 - Turn unlock)
1. If assist door unlock knob (below unlock knob) is turn to Unlock from Lock, then the Unlock output shall be ON to all doors for T1.
2. If assist door unlock knob is turn to Lock from Unlock, then the Lock output shall be ON to all doors for T1.
3. If driver/assist door KEY LOCK switch is turn to ON from OFF, then the Lock output shall be ON to all doors for T1.
4. When the TX Lock signal is received, the door Lock output shall be ON for T1.
5. If the driver door Key Unlock switch is turn to ON from OFF, then the driver door Lock switch shall be unlocked mechanically. (The BCM &
RECEIVER shall not be output.)
(After being unlocked mechanically, if the same condition is satisfied within T2, then the Unlock output shall be ON for T1 to all doors.)
(After the TX Unlock signal is received, if the same condition is satisfied wsatisfied2, then the Unlock output shall be ON for T1 to all doors.)
6. When the TX Unlock signal is received, the driver door Unlock output shall be ON for T1.
If the TX Unlock signal is received within T2, the Unlock output shall be ON to all doors for T1. (After the driver door Key Unlock switch is
turn to ON from OFF, if the same condition is satisfied within T2, then the Unlock output shall be ON to all doors.)
-
If, within T2, other registered TX signals are received, they shall be treated as the same TX signal.
-
The Lock (Unlock) output by the changing of the driver door unlock knob shall not be performed.
-
In the state of being all unlock knob in Lock position, if Lock signals of TX, driver, assist (Tail Gate) door Key switch are input, the
second Lock output shall not be performed.
-
In the state of being all unlock knob in Unlock position, if Unlock signals of TX, driver, assist (Tail Gate) door Key switch are input, the
second Unlock output shall not be performed.
4. KEYLESS ENTRY & CENTRAL DOOR LOCK/UNLOCK(BCM & RECEIVER ONLY)
1. When the TX Lock is ON, the Hazard Lamp shall be output at one time for T2 after Lock Relay is output for T1.
-
However, after the TX lock is ON, during waiting for the Hazard output, if the Key is inserted(KEY IN SW=ON), then the Hazard Lamp
output shall not be performed.
-
After the TX lock is On, if Key is inserted within 0.5 sec (KEY IN SW=ON), keep the prior state without alarm being entered.
