Rio5 L4-1.6L (2006)
prevent damaging it when pivoting the caliper down.
5. Pivot the caliper down into position. Being careful not to damage the pin boot (A), install the guide rod bolt (B) and tighten it to the specified
torque.
6. If caliper assembly was removed, install the brake hose to the caliper.
7. Refill the master cylinder reservoir to the MAX line.
8. Bleed the brake system.
9. Depress the brake pedal several times to make sure the brakes work, then test-drive.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
applications of the brake will restore the normal pedal stroke.
10. After installation, check for leaks at hose and line joints or connections, and retighten if necessary.
