Rio5 L4-1.6L (2006)
a. Disconnect connectors (A), (C) and measure for resistance between connector (A) and Chassis Ground as shown in [FIG. 6].
The measured resistance of line 1 and 2 in this example is below 1 Ohm and higher than "IMS" respectively. Specifically the short to ground
circuit is line 1 (Line 2 is normal). To find exact broken point, check the sub line of line 1 as described in the following step.
b. Disconnect connector (B), and measure the resistance between connector (A) and chassis ground, and between (B1) and chassis ground as
shown in [FIG. 7].
The measured resistance between connector (B1) and chassis ground is 1 Ohm or less. The short to ground circuit is between terminal 1 of
connector (C) and terminal 1 of connector (B1).
