Rio5 L4-1.6L (2006)
1.
Slip the seat belt webbing through the slot in the new guide making sure the webbing stopper is outside of the webbing guide slot. From the rear of
the vehicle, reach over the top of the left seat back and squeeze around the opening for webbing guide as shown.
2.
Move webbing to the left and insert the right front webbing guide hook through the right slot in the webbing guide opening stiffener. Move the
webbing to the right side and repeat the procedure for the left front webbing guide hook.
3.
push the webbing guide forward until the rear webbing guide hooks clear the back of the webbing guide opening. Push the back of the webbing
guide down engaging the rear webbing guide hooks under the back of the webbing guide opening stiffener.
4.
Check to make sure all four front and rear webbing guide hooks are held properly by gently pulling up on all four corners of the webbing guide as
shown. If any of the webbing guide hooks are not held down repeat steps 1 through 3 above. Re-install off rear head rest.
