Rondo L4-2.4L (2007)
E. Beginning at the fuse box, slowly move the short finder along the circuit wiring. The meter will show current pulses through sheet metal and
body trim. As long as the meter is between the fuse and the short, the needle will move with each current pulse. Once the meter is moved past
the point of the short, the needle will stop moving. Check around this area to locate the cause of the short circuit.
5. TESTING FOR VOLTAGE DROP
This test checks for voltage drop along a wire, or through a connection or switch.
A. Connect the positive lead of a voltmeter to the end of the wire (or to the side of the connector or switch) closest to the battery.
B. Connect the negative lead to the other end of the wire. (or the other side of the connector or switch)
C. Operate the circuit.
D. The voltmeter will show the difference in voltage between the two points. A difference, or drop of more than 0.5 volts (50 mV in 5 V circuits),
may indicate a problem. Check the circuit for loose or dirty connections.
