Sedona V6-3.5L (2003)
Blower Motor: Service and Repair
Blower/Evaporator-Front
Removal
1. Discharge refrigerant from A/C system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper
procedures.
2. Disconnect inlet and outlet pipe from evaporator.
NOTE: Immediately plug all open fittings to keep moisture out of system.
3. Remove cover and drain hose.
4. Remove instrument panel and disconnect wiring harness connector.
5. Remove blower/evaporator unit.
Installation
1. Install blower/evaporator unit in reverse order of removal.
2. Evacuate refrigerant system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.
3. Charge A/C system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.
NOTE:
a. Immediately plug all open fittings to keep moisture out of system.
b. Apply clean compressor oil to O-rings before connecting fittings.
c. Do not apply compressor oil to fittings.
d. When installing new evaporator add compressor oil.
Compressor oil : 2.44 cu in (40 cc)
Tightening torque : 35 - 61 lb.in (4 - 7 N.m, 40 - 70 Kg.cm)
