Sedona V6-3.8L (2009)
OUTSIDE MIRROR MEMORY OPERATION BY THE MEMORY SWITCH
1. IMS Message from DDM is sent to RETURN1 or RETURN2, out side mirror returns to the position stored.
2. Memory permit status is released if any of the following conditions is met
A. If 5 seconds is elapsed after the memory switch is turned on
B. If the ignition 2 is turned off
C. When saving is completed
D. If Ignition switch of the CAN communication data sent by the IPM is not "Run" or "Start".
E. If Inhibit switch of the CAN communication data sent by the FAM is not "P".
F. If vehicle speed of the CAN communication data sent by the cluster is "3Km/h" or more.
3. Memory is cleared if the battery is removed
OUTSIDE MIRROR MEMORY AND REPLAY OPERATION BY THE MEMORY SWITCH
1. IMS message from DDM is sent to RETURN1 or RETURN2, O/S MIRROR returns to the position stored.
2. Replacing not stored position doesn't work.
3. If RETURN Message is sent during replacing, the last Message has priority.
4. Replacing Prohibition Conditions.
(1) If the mirror switch on the LH side is pressed
(2) If Ignition switch of the CAN communication data sent by the IPM is not "Run".
(3) If Inhibit switch of the CAN communication data sent by the FAM is not "P".
(4) If vehicle speed of the CAN communication data sent by the CLUSTER is "3Km/h".
OUTSIDE MIRROR MEMORY AND REPLAY OPERATION BY KEYLESS
1. Memory operation
A. If the ignition is turned off after being on, the position of the O/S mirror RH is saved in the switch ASSY power window main.
B. If the door was keyless-locked, the outside mirror RH position is saved corresponding to the keyless code.
2. Replay operation
A. If the door is keyless-unlocked while the IGN SW is off, replacing is made to the saved position corresponding to the keyless code.
3. Replay prohibit condition
A. When the inhibit "P" switch is OFF
B. When RH side mirror switch is pressed
C. When mirror switch is pressed after ignition on
D. When the vehicle speed is over 3km/h
AUTO REVERSE FUNCTION
FAIL SAFE FUNCTION
1. If the sensor does not move more than 60mV for the input changes (5 second operation) of the position sensor although the motor is operating, it
will be considered there is a harness cutting, motor breakdown, or sensor breakdown and automatic control will stop.
2. The mirror operation signal cannot be displayed into the same direction for more than 15 seconds. (When the mirror is replacing to the saved
position or the switch is manually pressed)
3. Monitoring the replacing time
A. If the replacing operation does not stop within 40 seconds, the mirror motor will not outputted and the replacing operation will stop.
COURTESY LAMP
1. If assist's door is opened, RAM changes door open Message to ON and Courtesy lamp is ON by ADM.
2. If assist's door is closed, RAM changes door open Message to Off and Courtesy lamp is OFF gradually by ADM.(5±0.5sec)
3. During dim out, If IGN changes to ON or door is closed while Ignition switch is ON, Courtesy lamp is OFF immediately.
4. If Key reminder switch is OFF and door is opened for 20min, Courtesy lamp is OFF immediately.
DEFOG CONTROL (O/S MIRROR HEAT LINE)
