Sedona V6-3.8L (2009)
Tire Pressure Sensor: Removal and Replacement
REMOVAL
TIRE REMOVAL
1. Deflate tire & remove balance weights.
CAUTION:
-
The tire bead should be broken approx. 180° from the valve side of the wheel. The bead breaker should not be set too deep.
-
Avoid tire/tool contact with the valve on dismount.
-
Dismount should end near the valve.
SENSOR REMOVAL
CAUTION:
Handle the sensor with care.
1. Remove the valve nut.
CAUTION:
The valve nut should not be re-used.
2. Discard the valve assembly.
INSTALLATION
SENSOR FIT
CAUTION:
-
Handle the sensor with care.
-
Avoid lubricant contact if possible.
1. Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
