Sedona V6-3.8L (2009)
Engine Control Module: Recalls
Campaign SA059 - ECM Update For MIL ON/DTC P0111
GROUP Engine
NUMBER 082
MODEL 2009-2010MY Sedona (VQ)
DATE October 2010
SUBJECT: SERVICE ACTION: MIL ON WITH DTC P0111 DTC LOGIC IMPROVEMENT (SA059)
This bulletin provides the procedure to upgrade the Electronic Control Module (ECM) of some 2009-2010 Model Year Sedona vehicles. Some vehicles
may experience a Malfunction Indicator Lamp (MIL) illuminated with system-related DTC P0111 stored in the ECM.
- P0111 Intake Air Temperature Sensor 1 Circuit Range/Performance
For confirmation that the latest reflash has been performed to a vehicle you are working on, verify ROM ID using the tables in this TSB.
To correct this condition, the ECM should be reprogrammed using the GDS download as described in this bulletin.
NOTICE
A Service Action is a repair program without customer notification that is performed during the warranty period. Any dealer request to perform this
repair outside the warranty period will require DPSM approval.
Repair status for a VIN is provided on WebDCS (Service > Warranty Coverage > Warranty Coverage Inquiry > Campaign Information). Not
Completed Recall/Service Action reports available on WebDCS (Consumer Affairs > Not Completed Recall Recall VIN > Select Report).
The issue number is SA059.
UPGRADE EVENT IMPROVEMENT
NOTICE
^ A fully charged battery is necessary before ECM upgrade can take place. It is recommended that the Midtronics GR8 system be used in ECM mode
during charging. DO NOT connect any other battery charger to the vehicle during ECM upgrade.
^ All ECM upgrades must be done with the ignition key in the "ON" position with the blower motor in the "OFF" position during ECM upgrade.
^ Be careful not to disconnect any cables connected to the vehicle or GDS during the PCM upgrade procedure.
^ DO NOT start the engine during ECM upgrade.
^ DO NOT turn the ignition key "OFF" or interrupt the power supply during ECM upgrade.
^ When the ECM upgrade is completed, turn the ignition "OFF" and wait at least 10 seconds before starting the engine, according to instructions
displayed on the GDS tool.
^ ONLY use approved ECM upgrade software designed for the correct model, year.
