Sedona V6-3.8L (2009)
Alarm Module: Service and Repair
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad. .
3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) with bracket (B) located on the cowl cross bar. after
loosening the shear bolt.
NOTE:
-
Punch the shear bolt using a centering punch.
-
And drill its head off with a drill bit.
-
Be careful not to damage the SMARTRA unit.
4. Installation is the reverse of removal procedure.
NOTE:
-
Tighten the shear bolt until the bolt head break off.
