Sedona V6-3.8L (2009)
OUTSIDE MIRROR MEMORY AND REPLAY OPERATION BY KEYLESS
1. Memory operation
A. Outside mirror LH position is registered in the driver side power window switch when the ignition is turned off from on.
B. When door is locked by the keyless, outside mirror position is registered corresponding to the keyless code.
C. Data related to the memory operation is received from BCM in CAN communication.
2. Replay operation
A. When door is unlocked by the keyless under ignition off state, it replays the position corresponding to the keyless code.
B. Data related to the replay operation is received from BCM in CAN communication on CAN line.
3. Replay prohibit condition
A. If the mirror switch on the LH side is pressed
B. If Ignition switch of the CAN communication data sent by the IPM is not "Run" or "Start".
C. If Inhibit switch of the CAN communication data sent by the FAM is not "P".
D. If vehicle speed of the CAN communication data sent by the CLUSTER is "3Km/h" or more.
OUTSIDE MIRROR MEMORY AND REPLAY OPERATION BY KEYLESS
1. Memory operation
A. Outside mirror LH position is registered in the driver side power window switch when the ignition is turned off from on.
B. When door is locked by the keyless, outside mirror position is registered corresponding to the keyless code.
C. Data related to the memory operation is received from BCM in CAN communication.
2. Replay operation
A. When door is unlocked by the keyless under ignition off state, it replays the position corresponding to the keyless code.
B. Data related to the replay operation is received from BCM in CAN communication on CAN line.
3. Replay prohibit condition
A. When the inhibit "P" switch is OFF.
B. When RH side mirror switch is pressed.
C. When mirror switch is pressed after ignition on.
D. When the vehicle speed is over 3km/h
AUTO REVERSE FUNCTION
FAIL SAFE FUNCTION
1. If the sensor does not move more than 60mV for the input changes (5 second operation) of the position sensor although the motor is operating,
automatic control will stop.
2. The mirror operation signal cannot be displayed into the same direction for more than 15 seconds. (When the mirror is replacing to the saved
position or the switch is manually pressed)
3. Monitoring the replacing time
A. If the replacing operation does not stop within 40 seconds, the mirror motor will not outputted and the replacing operation will stop.
IMS SWITCH
1. If it's satisfied with the followings
(1) Can communication Data ignition switch sent by IPM is "RUN"
(2) Can communication Data Inhibit switch sent by FAM is "P"
(3) Can communication Data vehicle speed sent by CLUSTER is under "3Km/h"
2. If SET switch is ON, IMS message is SET.
3. If POSITION switch is ON within 5sec since SET switch is ON, IMS message will be sent to MEMORY1 or MEMORY2.
SEAT MANUAL SWITCH
If Seat switch is controlled, seat control message is sent to seat.
