Sedona V6-3.8L (2009)
or the weight slides, the check result may not accurate, and could result in unwanted fail
-
When the measured weight deviates from the standard value, check again all the fastening bolts are tightened properly. And make sure
there is no interference. During the tightening, be careful not to deform the seat rail or seat structure. If the accuracy check is still not inside
the standard value, replace the seat leg assembly.
-
When WCS reset operation not finished normally, replace the seat leg assembly.
5. After installing the OCS, confirm proper system operation : Turn the ignition switch ON, the SRS indicator should be turned on for about six
seconds and then go off.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require
supperssion and the passenger airbag is enabled.
