Sedona V6-3.8L (2009)
11. After applying the specified fluid to the oil seal, install it in the rack housing and fix the valve body assembly(A) and O-ring in the gear box(B).
12. Install the rack support yoke (A), rack supports spring (B), yoke plug (C) and lock nut (D) in the order shown in the illustration. Apply
semi-drying sealant to the threaded section of the yoke plug before installation.
13. With the rack placed in the center position, attach the yoke plug to the rack housing. Tighten the yoke plug to 12 Nm (120 kg-cm, 8.9 lb-ft), with a
14mm socket (A). Loosen the yoke plug approximately from 30° to 60° and tighten the yoke nut to the specified torque.
Tightening Torque Nm(kgf-m, lb-ft) :
50 - 70(5 - 7, 37 - 52)
14. Tighten the feed tube (A) to the specified torque and install the mounting rubber using adhesive.
15. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
Recommended grease : Silicone grease
