Sedona V6-3.8L (2009)
NOTE:
Bring clamp (C) of stabilizer bar (A) into contact with bushing (B).
2. Install the bracket on the bushing (B).
3. After tightening the bolts of the bushing bracket temporarily, install the bushing bracket on the opposite side.
4. Install the stabilizer bar bracket mounting bolts (A) to the sub frame.
Tightening torque Nm (kgf.m, lb-ft) : 39 - 60 (3.9 - 6.0, 28.2 - 43.4)
5. After lifting the jack which supports the sub frame, install the four bolts (A) of the sub frame and the eight bolts (B) of the guide bracket.
Tightening torque Nm (kgf.m, lb-ft) : Bolt (A) : 160 - 180 (16 - 18, 115.7 - 130.2) / Bolt (B) : 45 - 60 (4.5 - 6.0, 32.5 - 43.4)
6. Install the engine mounting bolts (A, B)
Tightening torque Nm (kgf.m, lb-ft) : 65 - 85 (6.5 - 8.5, 47.0 - 61.5)
7. Install both sides of the lower arm (A) mounting bolts(B).
Tightening torque Nm (kgf.m, lb-ft) : 90 - 120 (9 - 12, 65.1 - 86.8)
