Sedona EX V6-3.5L (2002)
Rear Bumper: Service and Repair
Removal
1. Remove rear combination light assembly.
a. Remove two mounting screws.
b. Disconnect electrical connector from rear side of light assembly.
2. Remove bumper assembly.
a. Remove four fasteners and four retaining screws from top of bumper assembly.
b. Remove mud flap from bumper assembly.
c. Remove two screws from bottom of bumper assembly.
d. Remove two screws from side of bumper assembly.
e. Remove four bumper mounting bolts from under of vehicle.
Installation
Install rear bumper in reverse order of removal.