Sedona EX V6-3.5L (2002)
1. Install a new gasket onto the power brake booster studs.
2. Have an assistant position the power brake booster.
3. From inside vehicle, install four nuts. Tighten the power brake booster nuts.
Tightening torque: 14 - 19 ft. lbs. (19 - 26 Nm, 1.9 - 2.6 kg-m)
4. Lubricate the clevis pin with grease and install it.
5. Install a new pin.
6. Position the vacuum booster hose to the power brake booster and install the vacuum hose clamp.
7. Position the brake master cylinder and install the two nuts. Tighten the brake master cylinder nuts.
Tightening torque: 9 - 16 ft. lbs. (13 - 21 Nm, 1.3 - 2.2 kg-m)
8. On manual transaxle vehicle, position the clutch master cylinder and install the clamp.
9. Uncap the brake pipes and the brake master cylinder ports.
Caution: When installing the primary and secondary brake pipes on master cylinder, be sure brake pipe do not contact any other components
within the vehicle and that there is slack in the flexible sections of the pipes. This is required due to the movement between the ABS hydraulic
control module (HCU) and the master cylinder, when the vehicle is in motion.
10. Connect the brake pipes to the brake master cylinder and tighten the brake pipe flare nuts.
Tightening torque: 9 - 16 ft. lbs. (13 - 21 Nm, 1.3 - 2.2 kg-m)
11. Connect the brake master cylinder connector.
12. Install a battery.
13. Bleed the brake system.
