Sedona EX V6-3.5L (2002)
2. Remove the sensor bolt and remove the speed sensor.
Inspection
1. Check clearance.
Measure the clearance.
Specified clearance: 0.0039 - 0.048 inch (0.1 - 1.2 mm)
2. Measure speed sensor resistance
Resistance: 1275 - 1495 Ohms
Replacement
1. Clean the speed sensor attaching surface.
2. Install the speed sensor.
Tightening torque: 6 - 7 ft. lbs. (8 - 9.5 Nm, 82 - 97 kg-cm)
3. Install the wiring harness connector with wheel speed sensor cable.
Be sure speed sensor cable connector is fully seated and locked into vehicle wiring harness connector.
4. Check the air gap between the face of the wheel speed sensor and the top surface of the tone-wheel.
Air gap: 0.0039 - 0.048 inch (0.1 - 1.2 mm)
5. Road test vehicle to ensure proper operation of the base and ABS brake system.