Sedona EX V6-3.5L (2002)
WARRANTY COVERAGE: BASIC (NEW VEHICLE LIMITED WARRANTY)
Front No. 1 Pipe Assembly Removal and Installation
Service Procedure - Front No. 1 Pipe Assembly Removal
1.
Once the engine has cooled sufficiently, remove the radiator cap.
Raise vehicle on lift. Cut the two flexible coolant hoses between the front coolant pipes and center coolant pipes as shown in the photo, and allow
coolant to drain into a large container.
NOTICE:
A large amount of coolant will drain from these two hoses.
2.
Remove the catalytic converter as shown.